Knowledge Base

Home / Knowledge Base / Using UltraSMTP / Getting Started With UltraSMTP


Getting started with UltraSMTP just a few minutes. Please follow the steps below to get started.

1) If you've not done so already, setup an account with UltraSMTP.

2) Be sure to complete the payment process though Paypal (99 cents for a 30-Day trial account, $29.00/yr for an UltraSMTP Pro account) after setting up your new account. Your account will not be activated until you complete the payment. If you haven't yet completed the payment, you can do so now by logging in to your account.

3) Verify the email address that you used to sign up with. After signing up, you should have received a welcome email from UltraSMTP sent to the email address that you signed up with, containing a link to verify this email address. Click on the link to verify this email address. You will not be able to send email from this address through UltraSMTP until verifying this address. If you need UltraSMTP to resend the verification email, you can do so by logging in to your account.

4) Configure your mail client to send outgoing mail through UltraSMTP. Please refer to our configuration guide for instructions.

5) If possible, setup an SPF record for the domain from which you send email. Although not absolutely necessary, this will increase the likelihood of your messages being successfully delivered to your recipients' inboxes.

Note: Messages sent through UltraSMTP must be sent FROM an email address registered on your UltraSMTP account. You can register up to ten email addresses on your account, by logging into your account at the UltraSMTP web site (under 'account preferences').

In case of any question or problems, please contact us.

New from the creators of UltraSMTP:
EncryptedSend - Browser based end-to-end encrypted messaging

© Meixler Technologies, Inc. All Rights Reserved.